منتجات

Shaking Table Modeling

Shaking table modeling of MSE/soil nail hybrid retaining

2019-4-1  A series of 1-g shaking table tests using variable-amplitude harmonic excitations was performed on 0.8-m-high MSE/soil nail hybrid retaining (MSE/SN) wall models to investigate

احصل على السعر

Shaking Table Modeling of Seismically Induced

Physical model experiments were performed on a 1 g shaking table with the principal goals of: (1) investigating the mechanisms of seismically induced permanent deformations in slopes, and

احصل على السعر

Modeling and controller design of a shaking table in an

2008-11-1  Considering servo-valve as a proportional element, let system gain K=0.1, measurement frequency response of the shaking table with 1–30 Hz white noise input is

احصل على السعر

Shaking Table Model Test to Determine Dynamic

2022-3-19  A model of a steep bedding rock slope with a slope angle of 50° and rock dip angle of 55° was designed and fabricated, and a large-scale shaking table test was carried out to

احصل على السعر

Shaking table tests modelling small diameter pipes

2012-4-1  Shaking table tests were performed on model pipelines, instrumented with strain gauges, under single gravity conditions to study the effect of combined large fault movements

احصل على السعر

Shaking Table Modeling of Embankment Slope

Shaking Table Modeling of Embankment Slope Response to Earthquake Loading Lin Yu-liang School of Civil Engineering, Central South University, Changsha 410075, CHINA

احصل على السعر

Shaking Table Model Test of Loess Tunnel

2020-2-14  Shaking Table Model Test of Loess Tunnel CHENG Xuan-sheng 1,2, ZHOU Xin-hai 1,2, WANG Ping 3, CHAI Shao-feng 3, FENG Huan 4, YANG Li-ping 5 1. Western

احصل على السعر

Development of the Shaking Table and Array System

2019-4-10  Shaking table is important experimental equipment to carry out antiseismic research. Research, conclusion, comparison, and analysis concerning the developmental history,

احصل على السعر

Shaking table testing and numerical modeling of

In order to confirm the validity of the ideal elasto-plastic resistance model applied to the ballast track under seismic loading, this paper studies the seismic response of continuous welded

احصل على السعر

Shaking Table Modeling of Seismically Induced

Physical model experiments were performed on a 1 g shaking table with the principal goals of: (1) investigating the mechanisms of seismically induced permanent deformations in slopes, and (2) assessing the accuracy and applicability of the Newmark sliding block procedure for estimating seismically induced deformations in slopes. Each of the clayey slope models deformed in

احصل على السعر

Shaking Table Modeling of Seismically Induced

Physical model experiments were performed on a 1 g shaking table with the principal goals of: (1) investigating the mechanisms of seismically induced permanent deformations in slopes, and (2) assessing the accuracy and applicability of the Newmark sliding block procedure for estimating seismically induced deformations in slopes. Each of the clayey slope models deformed in

احصل على السعر

Shaking Table Modeling of Embankment Slope

Shaking Table Modeling of Embankment Slope Response to Earthquake Loading Lin Yu-liang School of Civil Engineering, Central South University, Changsha 410075, CHINA linyuliang11@163

احصل على السعر

Full‐scale shaking table test and numerical modeling of a

This paper presents the numerical and experimental evaluation of a vertical-rocking isolation (VRI). This evaluation is done by 1-D shaking table tests performed on a full-scale legged storage tank of 3000-liters capacity and its representation through a simple yet representative rigid lumped-mass model approach.

احصل على السعر

Shaking Table Test with Finn Model: Simulation

2022-6-7  In the following example, a “shaking table” is modeled with FLAC3D. In this simple example, a “shaking table” is modeled with FLAC3D —this consists of a box of sand that is given a periodic motion at its base. The motion of the

احصل على السعر

Development of the Shaking Table and Array System

2019-4-10  Shaking table is important experimental equipment to carry out antiseismic research. Research, conclusion, comparison, and analysis concerning the developmental history, constructional situation, performance index, control algorithm, and experimental technique of the internal shaking table were reviewed and compared. Such functional parameters as internal

احصل على السعر

Shaking Table In Ore Processing Fote Machinery

2022-7-5  The shaking table is mainly used for the separation of copper, tungsten, tin, tantalum, niobium, chromium, gold and other rare metal and precious metal ores. In addition, it is widely used in the separation of iron,

احصل على السعر

Design, Manufacturing and Testing of Small

2018-11-28  The facilities of this shaking table, the movable base has a dimension of 0.8m x1.2m and the platform mass approximately 2 kN, the maximum allowable model weight of 10kN, the range of frequency

احصل على السعر

李培振 Tongji University

2016-10-13  56.Yanmei LIU, Xilin Lu, Guoqiang YANG. Comparative shaking table model tests on the soil-pile-structure interaction system in various liquefiable soils. The 11th International Symposium on Structural Engineering, 2010.11.17-19, Guangzhou, China (oral

احصل على السعر

发表论文下载,防灾减灾,地震工程,结构分析 Lu Xinzheng

2022-6-25  Jiang Q, Lu XZ, Guan, H, Ye XG, Shaking table model test and FE analysis of a reinforced concrete mega-frame structure with tuned mass dampers, The Structural Design of Tall and Special Buildings, 2014, 23: 1426-1442.

احصل على السعر

Shaking Table Modeling of Seismically Induced

Physical model experiments were performed on a 1 g shaking table with the principal goals of: (1) investigating the mechanisms of seismically induced permanent deformations in slopes, and (2) assessing the accuracy and applicability of the Newmark sliding block procedure for estimating seismically induced deformations in slopes. Each of the clayey slope models deformed in

احصل على السعر

UC Berkeley Shaking Table History Pacific Earthquake

2022-7-10  An MTS model 469 controller commands the shaking table′s movement. The controller provides for closed loop control of motion in translation and rotation about the 3 principal axes. The controller is designed so that each of these 6 degrees of freedom can be programmed individually and run concurrently.

احصل على السعر

Shake Tables Structural Engineering and Earthquake

2022-7-6  Overview. Two high-performance, relocatable, six-degrees of freedom shake tables are located in a trench along the north wall of the main laboratory. The tables can be controlled either independently or as a single, synchronized table. Together, the tables can support specimens weighing up to 100 metric tons with a length up to 120 feet.

احصل على السعر

Shaking Table Test with Finn Model: Simulation

2022-6-7  In the following example, a “shaking table” is modeled with FLAC3D. In this simple example, a “shaking table” is modeled with FLAC3D —this consists of a box of sand that is given a periodic motion at its base. The motion of the

احصل على السعر

A Detailed Dynamic Model of a Six-Axis Shaking Table

2008-5-2  This article describes the modeling of a 5 m × 5 m 6 degree-of-freedom (DOF) shaking table and the subsequent computer simulation of the system's dynamic characteristics. The simulation model is required to aid the development of a closed-loop controller with a bandwidth specified up to 120 Hz, and thus high order dynamics including valve response and structural

احصل على السعر

Design, Scaling, Similitude, and Modeling of

2010-9-28  – distorted model Shake Table Training Workshop 2010 San Diego, CA. Example of Adequate/Distorted (?) Model Small-scale specimen Large-scale specimen 300 350 150 200 250 e ral force, kips 1/5-scale specimen 0 50 100 00.5 11.5 2 Lat 2/3-scale specimen Shake Table Training Workshop 2010 San Diego, CA

احصل على السعر

Shaking table testing and numerical modeling of

In order to confirm the validity of the ideal elasto-plastic resistance model applied to the ballast track under seismic loading, this paper studies the seismic response of continuous welded ballast track on bridges through the shaking table test and presents a process of updating the model based on the test results. The results indicate that the track constraint can improve the low

احصل على السعر

Shaking-Table Control by Real-Time Compensation of the

2004-2-26  An improved shaking-table control method has been developed. This method compensates the reaction force caused by a nonlinear specimen in real time, and thus maintains a desired table acceleration. To do so, it identifies the difference between the desired and the actual transfer characteristics of the shaking table, then compensates for the difference.

احصل على السعر

Design, Similitude Scaling, and Simulation of a Shake

2018-12-4  Shake Table Training Workshop 2015 San Diego, CA NHERI @ UCSD Workshop, 14-15 December, 2015 1818 Tuning of the Shake-Table Tuning of the shake-table system for the given scaled records at bare table condition (On-Line Iterative compensation method OLI). 0 0.2 0.4 0.6 0.8 0 0.5 1 1.5 2 2.5 3 3.5 T (sec) S a) Acceleration spectrum Target

احصل على السعر

Improvement of control performance in shaking-tables by

This paper presents a practical control methodology of shaking tables for earthquake simulators. Reaction force generated by a nonlinear specimen on the shaking table generally deteriorates the motion performance of the table, resulting in the lower control accuracy of seismic tests. In order to provide the precise table motion, therefore, a compensator for the reaction force is designed

احصل على السعر

كسارات ثابتة

طاحونة

كسارات متنقلة

آلة التعدين